Sending engineering data

<< Click to Display Table of Contents >>

Navigation:  Data processing > EngPart > Sending and receiving engineering data >

Sending engineering data

Own and other information entered in the EngPart module can be used to create new sending jobs to a large extent automatically. For this the appropriate option in the Partner Administration (EngPart) has to be activated once. Just check the box Send engineering file(s) with EngPart at the bottom of the menu Partner Data Administration and leave the menu by clicking the Close button.

 

EngPart_010

 

Now click the button New Job in the main tool bar of !MC5 and select the appropriate partner. The following window appears:

 

EngPart_011

 

First select the correct sender. Choose the department and the final recipient within. Repeat the same steps for the recipient. When done move to the second page named Files.

 

EngPart_012

 

On the right side of the window all files are listed for which you can enter ENGDAT information. Select the correct file format and generating system. Additionally you can enter intended purpose and a description. The default setting for the item engineering department is the sender department selected before. This may be modified if requested. In the lower section of the window (not visible in the screenshot above) a drawing description can be added.

 

If you are done with the input for one file, you can use the input as default setting for all other files by clicking the corresponding button. From now on you must edit only the fields which differ for each file. Close the window by clicking OK and proceed in creating the sending job as usual.